husqvarna lawn mower repair information

husqvarna lawn mower repair information in Lower East Side

husqvarna lawn mower repair information Lower East Side

husqvarna lawn mower repair information Lower East Side.Check the oil level, if there is no oil in the crankcase the piston may have become fused to the cylinder wall.
Spraying a penetrant or lubricant into the cylinder through the spark plug hole can sometimes loosen the piston otherwise it is likely the engine will need extensive repair work.
Check the battery to make sure it is completely charged.
Also check the cables to make sure they are tight and the battery posts are clean.
The spark plug may be loose and need tightening, the spark plug wire may be damaged or disconnected, or the spark plug may be clogged with oil, gas, and combustion residue.
If it is clogged it can be cleaned with a wire brush.
You may also need to reset the spark plug gap.
The spark plug gap can be checked and adjusted with a spark plug gauge to measure the gap between the center electrode and ground electrode on the end of the spark plug.
Check the choke to make sure it is not stuck in the open position otherwise the carburetor may need to be cleaned or adjusted.
The choke should be in the closed position when starting a lawn mower, however if the choke remains closed the engine will not start because the fuel and air mixture is too rich.
If this happens the carburetor must be completely cleaned out using a brush or rag and a spray or liquid carburetor cleaner.
If there is only a click sound when trying to start a lawn mower with an electric starter there may be a problem in the electrical system.
Use a multimeter to test the starter switch, alternator and any other electrical component.
Ï»¿ the sparkle ballyhoo may be open and need tightening the sparkle ballyhoo wire may be damaged or disconnected or the sparkle ballyhoo may be clogged with oil gas and combustion residue.
The sparkle secure break can be checked and adjusted with a sparkle secure gauge to measure the break between the center electrode and ground electrode on the end of the sparkle secure.
Ï»¿ the sparkle secure break can be checked and adjusted with a sparkle secure gauge to measure the break between the center electrode and ground electrode on the end of the sparkle secure.. husqvarna lawn mower repair information

BELT REPAIR on Husqvarn... (4:08:23)
6,068 views
"Replacing the drive belt. Visit my channel for more repair videos; www.youtube.com"